A SERVICE OF

logo

10
Adam Equipment Company 2012
5.3
REPLACING
THE
MAIN
PCB
Remove the left side cover to expose the MAIN PCB and speed sensor
assembly. Disconnect all cables and remove the old MAIN PCB and
replace with a new one, Re connect all cables to the PCB.
Unscrew the speed sensor and disconnect the cable from the PCB. Fit
the new sensor, fasten securely and re connect the cable to the PCB.
5.4 REPLACING
THE
DISPLAY
PCB
Lift the handle and lean it towards the rear of the counter, then from
the rear lift the display housing towards the front. Remove the 5 x
screws to expose the display PCB. Remove the 6 x PCB fixing screws and
connector from the PCB and replace the PCB. Refit the cable connector,
screws and housing.