2
Adam Equipment Company 2012
1.1 KEY
AND
PANEL
DESCRIPTION
[ON/OFF]
The power switch is located on the rear housing. Use this key to
turn the counter ON and OFF.
[START]
Press the [START] key to continue checking following the
detection of a counterfeit note. It can also be used to enter the
parameters for the MG and UV set up and BATCH number.
[BATCH]
Press the [BATCH] key to enter the BATCH mode which enables
you to select the required quantity of notes to be counted.
[ADD]
Press this key to enable accumulation of the counted notes.
[+]
Press this key to increase the quantity in the BATCH display. It
can also be used to select settings in the parameter section.
[-]
Press this key to decrease the quantity in the BATCH display. It
can also be used to select settings in the parameter section.
[MG]
Press this key to select detection using the Magnetism sensor.
[UV]
Press this key to select detection using the Ultra Violet sensor.
