© Adam Equipment Company 2004
11
6.4 ENABLED UNITS
The default setting for the enabled units is any of the available units i.e. Grams,
Kilograms, Ounces, Pounds or Pounds & Ounces
NOTE: The currently-active unit cannot be disabled, hence to disable the
current unit an alternative unit must first be selected during normal
weighing.
• The display will show the first non-active unit, together with
!%
or
!##
to
indicate its currently-enabled state.
• Press the [Zero/Tare] key to change the enabled state of the currently-
displayed unit.
• Press the [Units] key to save any change to the enabled state of the currently-
displayed unit and display the next non-active unit, together with its currently-
enabled state.
• Press the [Cal] key to save any change of unit-enable state and return to
normal weighing.
7.0 VIEWING ADC COUNTS
• The ADC counts value may be viewed by holding the [Cal] and [Units]
keys pressed simultaneously at the end of the power-on display test.
• The raw ADC counts as a number from 0 to 30,000 will be displayed,
with 15,000 subtracted to give a displayed range of -15,000 to +15,000
counts.
• This mode can be exited at any time by pressing the [Cal] key, at
which point the scale will return to normal weighing mode.
8.0 LOADING DEFAULTS
• This function can only be performed by holding the [Cal], [Units] and
[Zero/Tare] keys pressed simultaneously at the end of the power-on
display test, and should only be carried out by qualified technicians.
