Appendix F. Frame Relay Firmware Version
F-4 Express 4100/4110 User Manual 61200176L2-1
DLCI Mapping/IP Map
Write security: 3, Read security: 5
This menu represents the IP protocol mapping that is to take place for this
DLCI.
IP Map/Active
Write security: 3, Read security: 5
When this is set to Yes (def), the Express 4100/4110 will attempt to
transport IP packets for this DLCI. A setting of No means that no IP
traffic or route will be exchanged.
IP Map/IARP
Write security: 3, Read security: 5
When this is set to Yes (def), the Express 4100/4110 will send
Inverse ARP packets in order to determine the IP address on the
other end of the virtual circuit. If the IARP is responded to, a route
is placed in the IP route table. A setting of No means that the route
address is to be assigned statically using the IP Map/Far-End IP
Address parameter. The Express 4100/4110 will always respond to
Inverse ARP requests.
IP Map/Far-End IP Address
Write security: 3, Read security: 5
This is the IP address of the device on the other end of the virtual
circuit. When this DLCI becomes active, the Express 4100/4110 will
add a route in the IP routing table.
IP Map/IP Netmask
Write security: 3, Read security: 5
The IP network mask to apply to the Far-End IP Address and Link
IP Address is specified here.
IP Map/Link IP Address
Write security: 3, Read security: 5
The virtual circuit may require an IP address to be specified at this
DLCI interface. This is called a numbered interface. This address is
used by the Express 4100/4110 to respond to Inverse ARP requests.
If this IP address is left as 0.0.0.0, the link is treated as unnumbered
