RADIO RECEPTION
Tuning into a station
1 Press TUNER ON/BAND repeatedly to select AM
or FM.
2 Press TUNING + (-) or - (W<) to tune into a
station.
After listening, press
■ STOP/OFF/CHARGE to turn off
the radio.
For quick tuning
Keep either TUNING + (_l) or – (W) pressed for 1
or 2 seconds. When a station is tuned in to, the frequency
stops automatically. However, it does not stop if the
broadcast signal is weak.
For better reception + ~
FM: The headphone cord functions as the FM antenna.
Keep it extended.
AM: Turn the unit to find the position which gives the
best reception.
To listen to an FM stereo broadcasting
Press MONO/ST repeatedly to display STEREO.
When the FM stereo signal is weak and distorted, press
MONO/ST again. STEREO display goes out and the
sound will be heard in monaural but distortion will be
reduced.
Note
● Do not open the disc compartment during radio
reception. The buttons will be deactivated.
● The power is turned off automatically if no operation is
made after 3 hours from the last operation during radio
reception.
AM/FM steps + O
● Radio broadcasts have differentfrequency ranges and
changes in different steps in different countries.
This unit is factory-set to 10 kHz steps on AM. When
using the unit where the AM step changes 9 kHz, set
the AM STEP switch in the battery compartment to
9 kHz.
