Installation
36 Instruction manual BFM
3
is
3.11 Checking the supply
pressure and burner
pressure
Note
Before starting the appliance and/or checking the supply pressure and
burner pressure, you must fill (5 "Filling") the appliance.
Caution
Before starting up for the first time or after conversion, you must always
check the supply pressure and burner pressure.
Note
The easiest way to check the gas pressures is by using two pressure
gauges. This procedure assumes that these two gauges are available.
If the appliance is to be run on a different gas category than the factory preset
gas category (see type plate) then you must first convert (4 "Conversion to a
different gas category") the appliance.
Gas control for BFM 30 through 100
Legend
1. burner pressure regulator
2. burner pressure regulator cap
3. burner pressure regulator
adjustment screw
4. gas control connector
5. blank plate
6. supply pressure test nipple
7. gas control
8. manifold test nipple
1
4
5
6
8
7
2
3
IMD-
2
R1
