105
INTRODUCTION NAVIGATION RADIO MODE CD MODE INDEXSETUPCD CHANGER
ENGLISH
DEUTSCH
DEUTSCH
DEUTSCH
✔ You will be asked to drive the route.
7 Use the
/ buttons on the rocker switch 7 to select START.
8 Carry out the steps as instructed by the system.
Carrying out the system test
You have the option of carrying out a system test. The system checks the GPS
antenna and whether the reversing signal and the vehicle ignition are correctly
connected to the system.
1 Select SYSTEM TEST menu item in the INSTALLATION setup menu.
2 Press the OK button 8.
3 Choose between SENSOR TEST, INTERNAL TEST and CALIBRAT. DATA.
✔ The displays containing the corresponding test results are shown.
Activating / deactivating the code LED
You can activate the code LED to indicate that your TravelPilot is theft protec-
ted. The code LED is located on the ON button 2. If CODE-LED is activated in
the setup menu, the ON button 2 flashes when the unit and vehicle ignition are
turned off.
To activate / deactivate the code LED,
1 select the CODE-LED menu item in the setup menu and
2 keep pressing the OK button 8 until the required ON or OFF setting is
displayed.
The code LED is activated / deactivated
SETTINGS
INSTALL
DEFAULT SET.
KEYCARD
FM-SEEK SENS
CODE-LED ON
INSTALLATION
SYSTEM TEST
CALIBRATION
GPS STATUS
