Finisher-AD1/Saddle Finisher-AD2/Puncher Unit-AT1/Document Insertion/Folding
Unit-F1/Document Insertion Unit-E1
3-21
3
Optional Equipment
■ Hole Punch Mode
The Hole Punch mode punches two or three holes (depending on the paper size) in the
printed sheets.
NOTE
•
The hole punched areas are shown in the illustration below.
•
The distance between the punch holes is shown in the illustration below.
IMPORTANT
•
The Hole Punch mode is available only if the Puncher Unit-AT1 is attached.
•
Only the following paper sizes can be hole punched: 11" x 17", LGL, LTR, LTRR, or
EXEC.
•
Holes cannot be punched in transparencies, tracing paper, labels, or pre-punched paper.
•
The machine automatically selects how many holes to punch depending on the selected
paper size.
- Two holes: LGL, LTRR, EXEC
- Three holes: 11" x 17", LTR
Platen Glass
Hole
Punched
Area
Hole
Punched
Area
Hole
Punched
Area
Hole
Punched
Area
Feeder
4 1/4"
(108 mm)
4 1/4"
(108 mm)
Three Holes Two Holes
2 3/4"
(70 mm)
