Chapter 5 Paper Handling 5-13
Paper Handling
Printing on Fabric Sheets
Canon Fabric Sheet FS-101 comes with a booklet that describes special handling
procedures. Be sure to read this booklet for special information on fabric sheets.
n
• Do not use the fixing agent provided with the Canon Fabric Sheet FS-101. This agent is
not necessary when printing with your unit.
• Do not touch newly printed fabric sheets until the ink has dried completely. This takes
about an hour.
Follow this procedure to load a fabric sheet in the multi-purpose tray:
1 Make sure the paper thickness lever is
set to e (right).
• For details, 1 p. 5-6.
c
Do not set the paper thickness lever
while the unit is printing since this
will cause problems.
2 With the cloth side towards you and
the open end at the top, insert one fabric
sheet into the multi-purpose tray q, and
align the right edge of the sheet with the
right side of the multi-purpose tray. Slide
the paper guide snugly against the left
edge of the sheet w.
3 Your unit is now ready to print. Set your
PC to print on the fabric sheet.
4 When the fabric sheet is printed, let it dry
for about an hour to allow the ink to dry
completely.
5 When dry, peel the film backing from the
printed fabric sheet.
