Chapter 5 Paper Handling 5-15
Paper Handling
2 Raise both paper output guides.
• You can hold the document tray up for
easy access to the paper output guides.*
3 Make sure the paper thickness lever is
set to e (right).
• For details, 1 p. 5-6.
c
Do not set the paper thickness lever
while the unit is printing since this
will cause problems.
4 Cut the banner paper along one of the
perforations to the length required. Then
gently fold along the perforations
between the first and second sheets.
• Your banner can be up to six sheets
(1782 mm) long.
5 Place the banner paper behind the unit
on a flat surface. Then insert the first
sheet into the multi-purpose tray q, and
align the right edge of the sheet with the
right side of the multi-purpose tray. Slide
the paper guide against the left edge of
the sheet, leaving a 1 mm gap between
the paper guide and the edge of the
sheet w.
• Make sure the sheet is under the tab on the
multi-purpose tray.
• Make sure the sheets behind the unit are
aligned with the multi-purpose tray.
