Infortrend
7-23
If there is a drive connected after the array is started, choose a drive
and press [ENTER]. Choose “Scan SCSI drive”, then press
[ENTER]. The menu may vary according to the drive status.
Choose the drive channel and ID of the drive you wish to scan, then
press [ENTER].
Slot Number
Drive Entry
These two functions are reserved for Fault Bus configuration.
Identifying Drive
Move the cursor bar to the drive you wish to identify, then press
[ENTER]. Choose “Identify SCSI drive,” then choose “flash all
drives” to flash the read/write LEDs of all the drives in the drive
channel. Choose Yes.
You may also choose “flash selected drive” or “flash all But
Selected drives” to flash the read/write LED of the selected drive
only, or all the drives except the selected drive. Choose Yes and
choose an extent of time from 1 to 999 seconds.
Deleting Spare Drive (Global / Local Spare Drive)
