A SERVICE OF

logo

P.O. Box 749 Peekskill, NY 10566 Tel: (845) 737-7009 Fax: (845) 737-0426 Web: www.compuvideosystems.com
Fig. 3
BNC Connector Wiring
To Install a BNC connector on the CAT-5 cable:
Push and crimp
1 pair from CAT-5 cable
With an oscilloscope connected to the output and the output cable terminated in 75 ohms,
1) Adjust the “Line” control CW to square off the sync.
2) Adjust the “Gain” control CW so that the sync signal is 400mv or if a 1VPP test signal is
available, adjust the “Gain” control for an overall level of 1VPP at the end of the cable.
3) Adjust the Hi-Freq. control CW until the sync edges just begin to peak.
Service: There are no servicble parts inside the unit. Please return to the manufacturer for
proper repair of this unit. Instructions are included in the Warrenty section.