www.desatech.com
114370-01D 9
INSTALLATION
Continued
4. Place log set assembly in center of replace
oor. Make sure front faces forward.
5. Install gas connector tube into gas supply t-
ting. Carefully shape tube to attach to adapter
tting being careful not to kink tube.
6. Install provided gas connector tube into the
gas inlet tting (see Figure 7, page 8).
7. Test for leaks following instructions under
Testing Burner for Leaks, page 10.
Repositioning Gas Inlet to Left Side of
Unit
1. Remove venturi and gasket by unscrewing
two screws under chassis (see Figure 8).
2. Unthread elbow fitting from orifice (see
Figure 8).
3. Remove orice and brackets by unscrewing two
screws on right side of unit (see Figure 8).
4. Install orice and brackets into left side of unit
using screws removed in step 1.
5. Install venturi and gasket under bottom burner
and into repositioned orice and brackets (see
Figure 8).
6. Thread elbow tting back into orice. Apply
thread sealant to orice threads (see Figure 8).
7. Install gas connector tube that comes with log
set into gas inlet tting (see Figure 8).
8. Install supplied brass adapter tting that comes
with log set into replace gas supply pipe. Use
thread sealant (see Figure 8).
9. Place log set assembly in center of replace
oor. Make sure front faces forward.
10. Install gas connector tube into gas supply t-
ting. Carefully shape tube to attach to adapter
tting. Be careful not to cause kinks in tube.
11. Test for leaks following instructions under
Testing Burner for Leaks, page 10.
TESTING BURNER FOR LEAKS
1. Generously apply noncorrosive leak detection
uid to all connections.
WARNING: Never check for
gas leaks with open ame.
2. Light burner with shutoff valve no more than
half open and holding a match slightly in front
of the pan (see Lighting Instructions).
3. Inspect all connections for bubbles, raw gas
odors, or flame from any area other than
burner. If leaks are detected, shut off gas valve
immediately. Tighten or reassemble the loose
connections using pipe joint compound until
burner system is leak free.
4. When nished testing, turn gas shutoff valve
OFF to extinguish all ames.
Figure 8 - Repositioning Gas Inlet to Left
Side of Unit
Outer
Bracket
Gasket
Venturi
Screws
Inner
Brackets
Orice
Elbow
Fitting
Elbow
Fitting
Inner Brackets
Orice
Gasket
Venturi
Screws
Chassis
Chassis
