EPSON EPL-N2700 Rev. A
Chapter 4 Disassembly/Assembly 110
4.2.19 Printhead Unit Removal
1. Remove the Rear Cover. (See Section 4.2.6.)
2. Remove the Top Cover. (See Section 4.2.11.)
3. Remove the Front Cover. (See Section 4.2.17.)
4. Remove the following screws and remove the Shield Cover. (See
Section 4.2.13.)
Sixteen screws (3501: marked with A in the figure) securing the
Shield Cover to the printer frame.
Three screws (1305: marked with B in the figure) securing the
Shield Cover to the Interface bracket.
5. Remove twelve screws (1305: marked with C in the figure) securing
the Main Circuit Board to the Main Circuit Board Mounting Plate.
6. Disconnect the control panel harness connecting to the Main Circuit
Board from the CN3.
7. Remove seven screws (1305) securing the Interface bracket to the
printer frame, and remove the Interface bracket along with the Main
Circuit Board by moving it upward.
8. Remove the Engine Controller Board. (See Section 4.2.14.)
9. Remove the Control Pane. (See Section 4.2.18.)
10. Remove four screws (3541) securing the Left Cover (rail) to the
printer fame and remove the left cover.
11. Remove five screws (3509) securing the lever to the printer frame
and remove the lever.
Figure 4-32. Lever / Left Cover Removal
