VNR 100 • Panels and Cabling 8
Panels and Cabling
This section provides information on:
• Rear Panel Features
• Front Panel Cover
• Front Panel Features
Rear Panel Features
a
b
chgfe
d
d
Figure 5. VNR 100 Rear Panel
a
AC power connector — use a standard IEC power cord to connect the recorder to a
100 to 240 VAC, 50 or 60 Hz power source.
b
PS/2 port for mouse (optional) — connect a PS/2 mouse to this port, if required.
c
PS/2 port for computer keyboard (optional) — connect a PS/2 keyboard to this
port, if required.
d
USB ports (2) — used to connect a mouse and keyboard for the initial configuration.
There are a total of four USB inputs: two rear panel and two front panel.
e
RS-232 control port — use an Extron cable (not provided) to connect the VNR100 to
a control PC.
f
VGA output connector — connect a local VGA monitor to this output.
g
Ethernet port 0 (eth0) — use an RJ-45 cable to connect this port to the primary
network (the VN-Matrix network).
h
Ethernet port 1 (eth1) — is not functional. Do not connect this port to a network.
