31
FAULT CODE DISPLAYS
When a fault occurs, the light above the Start / Pause button is red and secondary
panel light(s) inside the DishDrawer will indicate the type of fault which has occurred.
The DishDrawer will continuously beep every second until the Power button has been
pressed.
The fault codes are as follows and we recommend that you check the chart below to
correct the fault where possible. If the fault code cannot be removed by pressing the
Power button, turn the Power off at the mains supply, wait 10 seconds and turn the
DishDrawer on again. When the red light above the Start / Pause button has
disappeared, run the DishDrawer on a wash program to ensure the fault has been
completely eliminated. If the fault code still appears, call your Fisher & Paykel
Authorized Service Agent.
You are reminded that if you call a Fisher & Paykel Authorized Service Agent because
of a user fault, it is not covered by the Warranty. Should you encounter any problems
then we recommend that you telephone our Fisher & Paykel Customer Care Center on
1 888 9 367 872.
TLUAF
STHGILEVITACIDNI
ODOTTAHW
esniRyvaeHlamroNtsaFetacileD
2UEDOCTLUAF
rewarD
denepo
hsawgnirud
ll
ehtsserP rewoP nottub
.tluafehtraelcot
ehtsserpsyawlA
esuaP/tratS nottub
ehtgninepoerofeb
nisihsawfireward
ssergorp
3UEDOCTLUAF
tcerrocnI
retaw
erusserp
gnittes
pmupniarD
dekcolb
tcerrocnI
noitallatsnI
lll
retawehtegnahC
."PH"otgnitteserusserp
nonoitceSotrefeR
tnemtsujdAnoitpO
.edoM
rotomehtraelC
ngieroffoylbmessa
.lairetam otrefeR
resUnonoiceS
ecnanetniaM
.noitcurtsnI
otnoitallatsniehtkcehC
)s(esohniardehterusne
.dekniktonera
