Index
Chapter 5 Various Ways to Scan
Appendix
Glossary
Introduction
Contents
TOP
108
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
Various Ways
to Scan
Configuring
the Scan
Settings
How to Use
the Operator
Panel
4 Select [Auto Color Detection] for [Output mode].
5 Under [Select Current Image Setting], select the side(s) to
scan.
Configure the scan settings in the [TWAIN Driver (32)] dialog box.
You need to pre-configure settings for [Color/Grayscale] detection as
well as those for [Binary] detection.
6 Click the [OK] button in the [TWAIN Driver (32)] dialog
box.
D The settings are saved.
7 Perform a scan from ScandAll PRO.
For information on how to perform scanning, refer to "How to Use
ScandAll PRO".
When the document is recognized as a color/grayscale
document, it is output in the mode selected under [Image
Mode] in the [TWAIN Driver (32)] dialog box.
You can use a batch profile to change settings such as
the folders to save respective scanned color/grayscale
and black & white images, and their file formats and
names.
The procedure is as follows:
1 In the [Profile Editor] dialog box, select the [File
format and Name scheme] tab, and then select the
[Sort color and monochrome automatically] check
box.
2 Specify the respective folder names to save, the file
formats, and the file names for the color/ grayscale
and black & white images.
3 Click the [OK] button.
DThe settings are saved.
4 Perform a batch scan.
For information on how to perform batch scanning,
refer to "How to Use ScandAll PRO".
