Fujitsu M4097D Manual

A SERVICE OF

next previous

2-8

Setting the SCSI ID and the SCSI Terminator

The default of the SCSI ID is 5. The SCSI ID is set by using the Setup mode of the operator panel.

The procedure to change the SCSI ID is as follows:

1 Turn the power ON by

pressing the “I” side of the

power switch (see Figure

1.1). The scanner displays

“Scanner Ready” on the

lower line of the LCD.

2 Then press the “Next”

button. The scanner

displays “Mode select 1”.

3 Then press the “Next”

button twice. The scanner

displays “Mode select 2”

meaning that the setup

mode is ready.

4 Then press the “Enter”

button several times. The

scanner displays the

following:

5 Press the “Next” button

around times, then the

scanner displays “SCSI ID”

on the upper line of the

LCD.

6 Select the wished SCSI ID by pressing the “ ”or “ ” button, and press “Enter”. (the SCSI ID is

set.)

7 Press “Exit” to return to “Scanner Ready” screen if you don’t Need to change terminator.

NOTICE

If no other device is using the same SCSI ID, the scanner ID does not have to be changed.