A SERVICE OF

logo

Open as PDF
next previous
4. Using the handles on the housing labeled Blower 0 Blower 1, align the edge of the housing
over the edge at the top front of the cabinet, and slide it into place until the connectors at
the back of each housing are fully mated (Figure 3-15). Then tighten the thumbscrews at the
front of the housing.
Figure 3-15 Installing the Front Blower Housing
5. Unpack each of the four blowers.
6. Insert each of the four blowers into place in the blower housings with the thumbscrews at
the bottom (Figure 3-16).
74 Installing the System