A SERVICE OF

logo

Open as PDF
next previous
DYNAMIX HP-51M Coax MDU Master Bridge User’s Guide
36
dir
Show detail file information resides in flash ROM. Include
‘Working Area’ and ‘Upload Area’, refer Figure 4. The listed
filenames are,
‘bootcode’: boot loader
‘sysfw4m’: system firmware
‘G1C28H21M’: Master HCNA driver
‘G0C28H20Ep’: 3010 EP HCNA driver
‘G1C28H21Ep’: 3110 EP HCNA driver
‘diagsw’: 3010 diagnosis utility file
‘diagsw1’: 3110 diagnosis utility file
Accompanying with file id, file version, file date, and file size.
dns
[-s <pri/sec> <ip>]
Display or set up DNS server setting.
-s pri <ip>: set up Primary DNS server’s IP
-s sec <ip>: set up Secondary DNS server’s IP
exit
Close the Telnet console.
quit
Close the Telnet console.
ep
[-c <hostcnt>]
[-n <note>]
[-u <uprate index>]
<mac>
Set up the EP Properties Profile related setting values.
<hostcnt>: EP Host Limit setting value (0~255), default 255
<note>: EP Note setting value
<uprate index>: EP Upstream Rate setting value ( 0~1563,
*64Kbps), default 0 for unlimited
<mac>: designated EP MAC to configure
ephpnareboot
(Smart EP)
-m <mac>
Reset remote Smart EP device
epstat
(Smart EP)
-m <mac>
[-r]
Display remote Smart EP port statistics for port
LAN1/LAN2/HCNA.
-r: reset all port statistics counter to 0
epswc
(Smart EP)
-m <mac>
[-t]
[-u]
[-r]
[-d]
[-p <lan1/lan2/hpna>
[-l <up/down>]
[-s <auto /10h /10f
/100h /100f>]
[-f <on/off>]]
Display or set up remote Smart EP built-in switch Ethernet
properties
-t: display EP switch settings
-u: display EP switch/port status
-r: reset EP switch
-d: reset EP switch’s eeprom settings to factory default
-p: configure EP port LAN1/LAN2/HCNA
-l: link, <up/down>: force current port to link up or down, i.e.
enable/disable current port
-s: current port Ethernet mode setting,
<auto>: auto-negotiation mode
<10h/10f/100h/100f>: 10/100Mbps, half/full-duplex mode
-f: current port Ethernet flow-control setting,
<on/off>: turn on /off flow control
epswigmp
epswqosq
epswqosrate
epswqostc
epswtagvlan
(Smart EP)
-m <mac>
Refer swigmp, swqosq, swqosrate, swqostc, swtagvlan for the
same functionality, but operate on remote Smart EP with
designated MAC address <mac>
filter
[-s <set>
[-c <act/deact>]
[-a <ip> -m <mask>]
[-t <allow/deny>]
[-w <allow/deny>]
[-n <allow/deny>]
[-p <allow/deny>] ]
Display or set up the filter rule set, refer the section “Allow
Source” for IP <ip> and Subnet Mask setup <mask>.
<set>: filter set index, total 16 set (0~15)
<act/deact>: activate or de-activate the rule set
<allow/deny>: allow or deny the protocol
-t: telnet
-w: http/web
-n: snmp
-p: reply to ICMP ping
help
Display all commands with brief description