EN 69
MESSAGE
Memory full
–
–
99 events
maximum.
Enter correct value.
Your selection is not valid.
Set a value from 0 to 59.
Picture Wipe/Dissolve
functions and Black & White
Fader can not activate while
Sepia or Monotone is used.
This effect can not activate on
the in point of scene No. 01.
ⅷ POSSIBLE CAUSE
Ⅵ CORRECTIVE ACTION
ⅷ You tried programming over 99 scenes in a file.
Ⅵ First save the file currently opened then begin
programming scenes using a new file (
੬ pg. 53).
ⅷ You entered an incorrect device ID number.
Ⅵ Enter an ID number between 0 and 99 which is not
being used by another device (
੬ pg. 64).
ⅷ The value of the CUT OUT point is smaller than the
CUT IN point's.
Ⅵ Set the value of the CUT OUT point so that it is
larger than the CUT IN point's (
੬ pg. 54).
ⅷ You entered a value over 60.
Ⅵ Enter a value from 0 to 59 (
੬ pg. 54, 55).
ⅷ It is impossible to execute certain combination of
P.AE/Effects and Picture Wipes/Dissolve.
Ⅵ Cancel one of them or try another combination
(
੬ pg. 56).
ⅷ You tried to use a Picture Wipe/Dissolve (button
with a "P") at scene "01".
Ⅵ Use a Picture Wipe (button without a "P") at scene
"01" (
੬ pg. 57).
PROBLEM
Dubbing does not go as
programmed, or the
programmed playback
displays an image similar to a
Fader effect (black fader,
mosaic fader, etc.).
ⅷ POSSIBLE CAUSE
Ⅵ CORRECTIVE ACTION
ⅷ If the CUT IN point is programmed at the beginning
of a tape and programmed playback is to be
continued, the video device stops and programmed
playback is aborted.
Ⅵ Program the CUT IN point so that the tape is
forwarded/played back for approx. 20 to 30 sec.
from the beginning of the first recorded scene on the
tape (
੬ pg. 50).
ⅷ The counter may not be recognized due to dirt or
abnormalities on the tape.
Ⅵ When there are audio/video disturbances during
playback or when the scene's counter acts
abnormally, delete the scene from the programmed
playback or correct its CUT IN point (
੬ pg. 54).
