23
6. SETTING ON THE MENU SCREEN (Cont’d)
PROCESS SCREEN
Item
DETAIL It adjusts the emphasis level of the contour (DETAIL).
To make the contour (DETAIL) sharp : Increase numbers.
To make contour (DETAIL) soft : Decrease numbers.
+99
to
NORMAL
to
–99
OFF
MASTER
BLACK
+99
to
NORMAL
to
–99
AUTO KNEE OFF
ON
OFF
ON
KNEE
POINT
100%
95%
90%
85%
It varies the KNEE POINT where the compression starts.
(This is available only when the AUTO KNEE is set to OFF.)
To increase the KNEE POINT level : Increase the numbers.
To decrease the KNEE POINT level : Decrease the numbers.
When decreasing the number, the gradations at the high luminance level become
clearer.
WHITE CLIP It varies the point of the max. value in accordance with the high level video signal.
To increase the white clip point : Increase the numbers.
To decrease the white clip point : Decrease the numbers.
110%
105%
100%
Functions and operation Variable values
NEGA
This outputs the reversed video signal of the output terminal.
OFF : Reverse is not carried out.
ON : Reverse is carried out.
This adjusts the pedestal level(master black) which is the standard black level
when a lens cap is put on. When the pedestal level is increased, the whole screen
becomes brighter.
To increase the pedestal level: Increase the numbers (UP)
To decrease the pedestal level: Decease the numbers (DOWN).
It sets the AUTO KNEE function which compresses the video signal above a
certain level to display the gradation of the high lighted section. To check an
image with the gradation of a bright section, adjust the KNEE POINT manually.
OFF : AUTO KNEE function is not carried out.
ON : AUTO KNEE function is carried out.
