KODAK Display Manager System V4.1 User’s Guide 77
Troubleshooting
Characterization Failure
• Repeat the characterization making sure that the:
− Room is dimly lit or a dark cloth is placed over the monitor
− Sensor is securely attached to the monitor if the sensor has suction
cups
− Enable cable and the sensor connections are properly made
− Dark Gain Correction of the sensor is performed correctly
− Monitor is warmed up properly
• The monitor brightness may be set too low. Use the factory default setting.
If that fails, increase the brightness.
Verification Failure
• Repeat the calibration and characterization making sure that the:
− Room is dimly lit or a dark cloth is placed over the monitor
− Sensor is attached to the monitor securely if the sensor has suction
cups
− Enable cable and sensor connections are properly made
− Dark Gain Correction of the sensor is performed correctly
− Monitor is warmed up properly
• Refer to the Verification logs. See “Verification Logs” on page 73.
