A SERVICE OF

logo

25
APPENDIX B
Default Settings
Many functions of the scanner can be "programmed" - that is, enabled or
disabled. The scanner is shipped from the factory programmed to a set of default
conditions. The default parameter of the scanner has an asterisk (*) in the charts
on the following pages. If an asterisk is not in the default column then the default
setting is Off or Disabled. Every communication does not support every
parameter. If the communication supports a parameter listed in the charts on the
following pages, a check mark will appear.
Parameter Default RS-232*
Light Pen
UPC/EAN
*
aa
Code 128
*
aa
Code 93
*
aa
Codabar
aa
Interleaved 2 of 5 (ITF)
*
aa
MOD 10 Check on ITF
aa
Code 11
aa
Code 39
*
aa
Full ASCII Code 39
aa
MOD 43 Check on Code 39
aa
MSI-Plessey
aa
MSI-Plessey, 10/10 Check Digit
aa
MSI-Plessey, MOD 10 Check Digit
*
aa
Paraf Support
aa
ITF Symbol Lengths Variable
aa
Minimum Symbol Length 4
aa
Symbol Length Lock None
aa
Bars High as Code 39
*
a
Spaces High as Code 39
a
Bars High as Scanned
a
Spaces High as Scanned
a
DTS/SIEMENS