2 - 12 - 1
2 - 12 - 1
2 - 1
MANUAL No. 99MBH001B
2 OPERATION
22
22
2
OPERATIONOPERATION
OPERATIONOPERATION
OPERATION
2.1 Setting Power Source2.1 Setting Power Source
2.1 Setting Power Source2.1 Setting Power Source
2.1 Setting Power Source
The Digi-Derm operates from either dry batteries or AC power source.
Perform the following setup with the Digi-Derm turned
OFFOFF
OFFOFF
OFF.
1) Dry Batteries1) Dry Batteries
1) Dry Batteries1) Dry Batteries
1) Dry Batteries
Use four pieces of R6 (SUM-3). First, remove the battery lid on the
bottom of the case by pushing it in the arrow-marked direction, then set
the batteries over the ribbon in the proper polarity (+/-). Pulling the
ribbon removes the batteries.
Ribbon
Fig. 2
When the low battery indication "
ERRERR
ERRERR
ERR" is displayed or "three
decimal point indications" are turned on during operation, replace
the batteries with new ones.
2) AC Power Source2) AC Power Source
2) AC Power Source2) AC Power Source
2) AC Power Source
Connect the AC adaptor (Optional) to the AC adaptor jack of the
Digi-Derm, then to the AC power outlet.
