2 - 62 - 6
2 - 62 - 6
2 - 6
MANUAL No. 99MBH001B
2.3.2 Holding displayed value2.3.2 Holding displayed value
2.3.2 Holding displayed value2.3.2 Holding displayed value
2.3.2 Holding displayed value
Pressing the Hold key with the probe applied on the measured surface
holds the display with "
HH
HH
H" or "
←←
←←
←" (179-741) sigh indication. The
analog output is not held in the HOLD state (179-741). To release the
Digi-Derm from HOLD state, press the key again.
2.3.3 Outputting displayed value2.3.3 Outputting displayed value
2.3.3 Outputting displayed value2.3.3 Outputting displayed value
2.3.3 Outputting displayed value
If data print-out and processing are needed, connect the Data output
connector on the Digi-Derm to the Digimatic Mini-processor* (op-
tional) with the cable
No. 936937No. 936937
No. 936937No. 936937
No. 936937 (optional). To output the displayed
value to the processor, press the Print key on the Digi-Derm (except
for 179-741) or the data entry key on the processor. Data output can
also be performed in the HOLD state.
*179-741 additionally requires the A/D converter.
2.3.4 Rod stand2.3.4 Rod stand
2.3.4 Rod stand2.3.4 Rod stand
2.3.4 Rod stand
You can raise the rod stand folded in the bottom of the Digi-Derm so as
to incline the front panel. Since the rod stand can easily become de-
tached, don't use this stand as a carrying handle or for any purpose
other than as a stand.
2.3.5 Over indication2.3.5 Over indication
2.3.5 Over indication2.3.5 Over indication
2.3.5 Over indication
If "
OVEROVER
OVEROVER
OVER" or "
Initial displayInitial display
Initial displayInitial display
Initial display" (179-741) is displayed when the
probe is placed on the measured surface, this means that the thickness
is exceeding the measuring range of the Digi-Derm.
T > Measuring range
Coating
Base metal
Fig. 7
