15
3.3.7 Calibration Test
Calibration test feature allows a check of a known calibration mass against the last stored calibration information
in the balance. Sample display illustrates an 8.1 kg balance.
Procedure
• Press the Setup button, CAL is displayed.
• Press Enter button, CAL TYPE is displayed.
• Press Enter button, CAL TYPE InCAL is displayed.
• Press
button to select CALTEST calibration,
CALtESt is displayed.
• Press Enter button, WORKING is displayed.
NOTE: If a weight is left on the pan, the balance will
display CLR PAN (remove the weight from the pan). The
balance automatically resumes calibration.
• Display changes to PUT WT 8000 g. The displayed
weight is the full capacity of the balance.
• Place specified calibration mass on pan.
• Press Enter button, WORKING is displayed. After a
few seconds, DIFF is displayed. The display now
indicates the actual difference in weight between
what value was just placed on the pan and the
previous weight value which was stored in the
balance. After approximately 8 seconds, the display
returns to the WEIGH mode.
• Remove calibration test mass from the pan.
Setup
Use keys to change, press Enter
Change
Use keys to change, press Enter
Change
Setup
Setup
Use keys to change, press Enter
Change
Setup
press Enter
Change
g
Setup
g
Change
Mode
Units
Setup Print
Enter
Setup
Use keys to change, press Enter
Change
Mode
Units
Setup Print
Enter
Stable
g
