37
Function
11 ORIG. SET BEEP ADF Selects whether to enable the sound when 2:VALID
paper is placed on the ADF.
1:INVALID / 2:VALID
13 DEPT. COUNTER MODE Monitors the copy usage of each department. Consult your
1: TOTAL COUNTER authorized
2: DEPT. COUNTER service provider
3: DEPARTMENT LIST
16 LANGUAGE PRIORITY
Selects whether to enable the language selection
1:OFF
menu to display when the machine comes out of
the Energy Saver Mode, or when the RESET
button is pressed once.
1:OFF / 2:ON
17 DATE & TIME Sets the date and time.
Day, Month, Year, Time
Input the date and time using the Cursor Keys
and the Keypad.
18 DAYLIGHT TIME
Selects whether to enable the daylight time feature.
2:VALID
1:INVALID / 2:VALID
19 IP ADDRESS (DHCP)
*
1,
*
2
Displays the address which was reserved by
DHCP server.
20 SUBNET MASK (DHCP)
*
1,
*
2
Displays the address which was reserved by
DHCP server.
21 DEF. G/W IP (DHCP)
*
1,
*
2
Displays the address which was reserved by
DHCP server.
22 DHCP DEFAULT
*
4
Selects whether to enable the DHCP. 2:VALID
1:INVALID / 2:VALID
23 DNS SERVER ADDR
*
2
Selects whether to enable the DNS Server, and 2:VALID
sets its settings for Internet Fax/Email Function.
1:INVALID
2:VALID
<Sub Function>
1:HOST NAME / 2:DOMAIN NAME /
3:PRI. DNS SERVER (IP ADDRESS1) /
4:SEC. DNS SERVER (IP ADDRESS2)
24 MAC ADDRESS Indicates the MAC address.
25 HARD DISK FORMAT
*
3
Formats the hard disk.
26 HARD DISK ERR CHK
*
3
Selects the provision for the hard disk error check.
27 ABBR GROUP ID Inputs the group ID for the address book. 0
0-99
28 COMMUNITY NAME(1)
*
2
Selects whether to change the Community public
Name(1) SNMP.
Enables read only.
29 COMMUNITY NAME(2)
*
2
Selects whether to change the Community public
Name(2) SNMP.
Enables read/write.
■ General Settings (For Key Operator) (Continued)
No.
Modes Function
Initial
Setting
NOTE
*
1
When setting other than DHCP server Network settings, Parameter No. “22 DHCP DEFAULT” should be set to “INVALID”
first, then setup Parameter No.19 to 21.
*
2
When Parameter No.19 to 23 (except 22) and No. 28, 29 are set, cycle the power by turning the Power Switch on the Left
Side of the machine OFF and ON.
*
3
Available only when the optional Hard Disk Drive Unit is installed.
*
4
When not connecting to LAN, setting of DHCP should be INVALID. When setting of DHCP at VALID and the
machine is in Shutdown Mode, there may fax reception would not be accepted.
