“
25
Preparation
Programming Summary for the Answering
System
You can program the following functions using the handset near the
base unit. See the page numbers below for details.
The unit must be in the standby mode before programming.
≥To cancel during programming, press (FUNCTION/EXIT/CH). Start again from
the beginning.
≥If 6 beeps sound during programming, a wrong key was pressed. Enter
the correct number.
Lift the handset, and press (FUNCTION/EXIT/CH).
Press (›) or (‹) to select “Program”, and press FWD/EDIT (fl)
(Yes key).
To adjust the day and time, press (0). (page 26)
To set the remote code, press (1). (page 75)
To select the number of rings, press (2). (page 29)
To select the caller’s recording time, press (5). (page 28)
To store a pager number, press (#). (page 71)
≥The base unit display shows the setting of the selected adjustment or
function.
Press FWD/EDIT (fl) (Save key).
≥A beep sounds.
≥To return to the standby mode, press (FUNCTION/EXIT/CH).
≥If the handset displays “No link to base. Place on
cradle and try again.” and an alarm tone sounds,
move closer to the base unit and try again.
Press (›) or (‹) to select “TAD program”, and press FWD/EDIT (fl)
(Yes key).
≥“Answering system setting. See base unit.” is displayed on
the handset.
Base unit display
5=Recording time
6=Pager mode
7=Home number
≥Do not change the settings of
“Pager mode” ((6)) and “Home
number” ((7)). If you have changed
these settings, reset to the default.
(Pager mode: Recorded MSG,
Home number: No items)
