Can'tselectcertainchannel
• Channelmaynotbein ChannelMemory.Try pressingnumberbuttons.
• If usingVCR,checkto makesureTV/VCR switch on VCR is in correct
position.
• To select cable channels 100 thru 128, press number button 1 until 1--
appears. Then press other two number buttons. CABLE/MR function must
be in CABLE mode to select channels higher than 69.
• Channel may be locked-out with Parental Control feature.
...............................................................
I
Noisy stereo reception • May be a weak station. Change STEREO/SAP function to MONO setting
instead of STEREO.
No picture, no sound but power light
is on
Sound okay, picture poor
Picture okay, sound poor
• Maybe someone changed CABLE/AIR function to wrong position.
• Maybe a vacant channel is tuned.
• For Channels 90, 91, and 92, make sure the component connected to those
INPUT jacks is turned on in order to see the picture.
• If watching VCR (connected only through antenna input), make sure TV is
tuned to channel 3 or 4-same as CH3/CH4 switch on VCR. Also check to
make sure TV/VCR switch on VCR is in correct position.
• Check antenna connections.
• Try adjusting SHARPNESS function to improve weak signals.
No stereo on known stereo station • Make sure STEREO/SAP function is in STEREO mode.
Can't get two channels in Pix-in-Pix •
No picture while using Pix-in-Pix,
with S-VHS VCR or camcorder
Try another channel.
Try adjusting VOLUME, BASS, and TREBLE controls.
If station is sending stereo, Iry changing STEREO/SAP function to MONO
setting for clearer sound.
Try adjusting SRS (O) controls to turn SRS (O) off or on.
One channel must come thru ANTA or B jack and the other channel must
come thru the INPUT 1 or 2 jacks.
• If using the VCR1 or VCR2 button, make sure it is programmed to select the
proper video input channel as described on page -26.
• If using an S-VHS component, make sure its regular VIDEO cable is
connected to INPUT 1 VIDEO jack on the TV.
• If using a VCR, make sure theAUDIO and VIDEO OUT jacks on the VCR
are connected to the TV's AUDIO and VIDEO IN jacks.
• If you have an S-VHS VCR (or camcorder) connected, you must also
connect a cable from the VCR's VIDEO OUTjac k to the TV's corresponding
VIDEO IN jack in addition to the S-VHS cable.
Small picture does not have color. • The small picture will not have color if the large picture signal does not have
the color burst reference. All color signals and some black-and-white signals
are sent with color burst information. Try changing channels of the large
picture.
...........................................................................................................
Remote no longer controls cable box, • Try not to press any buttons on the remote while changing its batteries. You
VCR or audio equipment .... _may have to reprogram t_hepro_pe_rco_d_e-i_ntothe rem_ote: ...................
50 continued on next page
