14
English
Connections
Connecting to an Antenna
When the LED display is initially powered on, basic settings proceed automatically.
✎
Preset: Connecting the mains and antenna.
ANT OUT
Power Input
Setup (Initial Setup)
When the LED display is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings. Press the
POWER
P
button. Setup is available only when the Input Source is set to TV.
✎
Before turning on the LED display, make sure the antenna cable is connected.
1
Selecting a menu
language
Press the
u
or
d
button to select a menu language. Press ENTER
E
button
twice when done.
2
Selecting Store Demo
or Home Use
Press the
u
or
d
button, then press the ENTER
E
button.
x
Select the Home Use mode. Store Demo Mode is for retail environments.
x
To return the unit’s settings from Store Demo to Home Use (standard):
Press the volume button on the LED display. When you see the volume
OSD, press and hold MENU for 5 sec.
x
Store Demo is only for shop display. If you select it, several functions are
not able to use. Please select Home Use when you watch at home.
3
Selecting an area
Press the ENTER
E
button. Select the appropriate area by pressing the
u
or
d
button.
Press the ENTER
E
button to confirm your choice.
4
Auto Tuning
Press the
u
or
d
button to select correct option, and then press ENTER
E
button twice.
x
I use an aerial cable. Memorise all of the available channels using RF cable. (Auto Tuning
necessary)
x
I use a cable or satellite service. You don't need to use Auto Tuning to find channels.
✎
You can complete Setup by selecting it.
x
Air / Cable: Select the antenna source to memorise.
Digital & Analogue / Digital / Analogue: Select the channel source to memorise.
✎
You can check more details on page22.
5
Setting the Clock Mode Set the Clock Mode automatically or manually.
x
Auto: Select the time zone (depending on the country) where you are located.
x
Manual: Allows you to manually set the current date and time.
✎
If the customer chooses "I use a cable or satellite service." in step 4, the clock just
can be set manually.
6
Complete
Press the ENTER
E
button.
If You Want to Reset This Feature...
Select System - Setup (Initial Setup). Enter your 4 digit PIN number. The default PIN number is “0-0-0-0”. If you want to change the
PIN number, use the Change PIN function.
You should do Setup (MENU → System) again at home although you did in shop.
✎
If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode, which resets the PIN
to “0-0-0-0”: POWER (off) → MUTE → 8 → 2 → 4 → POWER (on).
