43
English
Other Information
Issues Solutions and Explanations
The PIP menu is not available. • PIP functionality is only available when you are using a HDMI source.
You turned the LED display off 45 minutes
ago, and it turned on again.
• It is normal. The LED display operates the OTA (Over The Aerial) function itself to upgrade firmware
downloaded whilst your watching LED display.
The message “Scramble signal” or “Weak
Signal/No Signal” appears.
• If you are using a CAM CARD (CI/CI+), check that it is installed into the common interface slot.
• If there is still a problem, pull the CAM CARD out of the LED display and insert it into the slot again.
There are recurrent picture/sound issues. • Check and change the signal/source.
A reaction may occur between the rubber
cushion pads on the base stand and the
top finish of some furniture.
• To prevent this, use felt pads on any surface of the LED display that comes in direct contact with
furniture.
✎
This panel uses a panel consisting of sub pixels which require sophisticated technology to produce. However, there may be a
few bright or dark pixels on the screen. These pixels will have no impact on the performance of the product.
¦ Storage and Maintenance
✎
If you attched some stickers on the LED display screen, it remains some debris after removing the sticker. Please clean it to
watch LED display.
✎
The exterior and screen of the product can get scratched during cleaning. Be sure to wipe the exterior and screen carefully
using the cloth provided or a soft cloth to prevent scratches.
Do not spray water or a cleaning agent directly onto the product.
Any liquid that goes into the product may cause a failure, fire, or
electric shock.
Clean the product with a soft cloth dapped in a small amount of
water.
[
CAUTION
If the height of "
A
" on one side is different from the other side,
adjust the heights.
