19
TROUBLESHOOTING
If the unit malfunctions, check out the following before calling for service.
Malfunction Check/Remedy
The chamber is not cooled
at all
￭ The circuit breaker of power source is active.
￭ The voltage is too low? (In this case, call an electrician.)
￭ The power switch is not ON.
￭ The large amount of articles (load) is stored in the chamber at one
time.
￭ The freezer is in defrost condition.
The cooling is poor
￭ The ambient temperature is too high.
￭ The door is not closed firmly.
￭ The large amount of frost is built on the chamber wall.
￭ The set temperature is not inputted properly.
￭ The freezer is in the direct sunlight.
￭ There is any heating source near the freezer.
￭ A rubber cap and insulation for the access port are not set correctly.
￭ You put too many unfrozen articles into the freezer compartment.
When the unit does not
accept changes of set-point
temperature
￭ The key lock is set in ON.
Noise
￭ The freezer is not installed on the sturdy floor.
￭ The freezer is not leveled with the leveling feet.
￭ There is anything touching the frame.
￭ The freezer is in the status immediately after start up.
The unit sometimes causes a noise when the chamber temperature is
high due to the large load. The noise gets less and less accompanying
with the cooling of the chamber.
Note:
If the malfunction is not eliminated after checking the above items, or the malfunction is not shown in the
above table, contact Sanyo sales representative or agent.
