ENGLISH
16
Operate the selected component for
playback.
5
Select the tone mode as desired.
7
Select the digital or the analog input as
desired.
4
At the tone defeat mode, each time the MULTI
CONTROL knob is rotated, the tone defeat mode
changes as follows:
DEFEAT ON : When listening to a program source
without the tone effect.
DEFEAT OFF : When adjusting the tone for your
taste.
At the desired tone (bass or treble), each time the
MULTI CONTROL knob is rotated, the tone level
can be adjusted within the range of +10~ -10 dB.
In general, we recommend the bass and treble to be
adjusted to 0(flat) level.
To complete tone adjustment, repeat the above steps
and .
Extreme settings at high volume may damage your
speakers.
Each time this button is pressed, the tone mode
changes as follows:
BASS TREBLE DEFEAT OFF(or ON)
The tone display is shown for 5 seconds.
If the tone display disappears, press the TONE
MODE button again.
( ) : When the tone defeat function is activated
(“DEFEAT ON”), bass and treble modes cannot be
selected
Note:
When the source direct function is activated, the
tone mode cannot be selected.
When playing back the program sources with
surround sound, refer to “ENJOYING SURROUND
SOUND” on page 21.
Adjust the (overall) volume.
6
At the desired tone mode, adjust as
desired.
8
When CD, TAPE MON or VIDEO 1~
VIDEO 4 is selected
Adjusting the tone (bass and treble)
Each time this button is pressed, the corresponding
input is selected as follows:
DIGITAL ANALOG
To listen to DTS, Dolby Digital or MPEG program
sources in the 2-CH downmix mode, in the stereo
mode, the digital input must be selected. (For
details, refer to “Downmixing into 2 front
channels” on page 24.)
When TUNER or AUX is selected as an input
source, the analog input is automatically selected.
Notes:
When the selected digital input is not connected.
“DIGITAL” flickers, meaning no sound. (Refer to
“ENJOYING SURROUND SOUND” on page 21.)
To select the digital input, you must match the
connected DIGITAL IN to the corresponding input
source.
(For details, refer to “When selecting the DIGITAL
IN SETUP” on page 37.)
