A SERVICE OF

logo

Open as PDF
next previous
Getting Started
13
Next, you must modify your PC’s network settings to enable it to communicate with the
CyberGuard SG appliance.
Click Start -> Settings -> Control Panel and double click Network Connections (or in
95/98/Me, double click Network).
Right click on Local Area Connection and select Properties.
Note
If there is more than one existing network connection, select the one corresponding to the
network interface card to which the CyberGuard SG appliance is directly attached.
Select Internet Protocol (TCP/IP) and click Properties (or in 95/98/Me, TCP/IP ->
your network card name if there are multiple entries) and click Properties.
Figure 2-1