38
GB
You can program the remote to control non-
Sony components. Once the control signals have
been memorized, you can use those components
as part of your system.
Furthermore, you can also program the remote
for Sony components that the remote is unable to
control. Note that the remote can only control
components that accept infrared wireless control
signals.
1 Press AV ?/1 while holding down RM
SET UP P.
RM SET UP P lights up once.
2 Press one of the input buttons to select
the input you want to control.
For example, if you are going to control a
DVD player, press DVD.
You can also select TV ?/1.
3 Press the number buttons to enter the
numeric code (or one of the codes if
more than one code exists)
corresponding to the component and
the maker of the component you want
to control.
See the tables starting from page 39 for
information on the numeric code(s)
corresponding to the component and the
maker of the component. (The first digit and
the last two digits of the numeric code
correspond to the category and the maker’s
code respectively.)
4 Press ENTER.
Once the numeric code has been verified,
RM SET UP P slowly flashes twice and
the remote automatically exits the
programming mode.
5 Repeat steps 1 to 4 to control other
components.
To cancel programming
Press RM SET UP P during any step. The
remote automatically exits the programming
mode.
To use the programmed input
Press the programmed input buttons.
If programming is unsuccessful,
check the following:
• If RM SET UP P does not light up in step 1, the
batteries are weak. Replace both batteries.
• If RM SET UP P flashes 4 times in quick succession
while entering the numeric code, an error has
occurred. Start again from step 1.
• In step 1, the remote automatically exits the
programming mode if 60 seconds has passed after
pressing RM SET UP P. Start again from step 1.
Notes
•RM SET UP P lights up while a valid button is
pressed.
• In step 2, if you press the input buttons several times,
only the last selected input is valid.
• In step 2, if you press TV ?/1, only TV VOL +/–,
TV CH +/–, TV/SAT, TV/VIDEO and WIDE
buttons are reprogrammed.
• In step 3, if you press the input buttons, the new input
is selected and the programming procedure returns to
the beginning of step 3.
• For the numeric codes, only the first three numbers
entered are valid.
To clear the memory of the
remote
Press ?/1, AV ?/1 and MASTER VOL – at the
same time. RM SET UP P flashes 3 times, then
goes off.
Programming the remote
