D 13373.08
NOVEMBER 2007
MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
Initial Conguration (1:4)
Simple IP Configuration
Configuration of the System Controller Board
Navigate to System Configuration > IP:
Verify the • IP Address set via the front panel LCD.
If applicable, set the • IP Address of Interface 2.
As a minimum you must configure Interface
1. If your TANDBERG MPS is connected to two
different IP networks, you must configure both
Interface 1 and Interface 2.
Please refer to section System Configuration
> IP Configuration for more details.
Configuration of the Media Board(s)
Navigate to System Configuration > Media Board IP:
Make sure to select the correct • Network ID.
When using only 1 IP network all Media
Boards should be set to Network ID 1.
Set the • IP Address for each of the installed
Media Boards.
Please refer to the section System Configura-
tion > Media Board IP for details.
Save - Press the Save button to save changes.
Simple IP Conguration
Configuration of the MPS using Web Interface
Open a web browser and type in the IP address to
access the web interface. The IP address to enter
was configured from the LCD during the installation
process.
