A SERVICE OF

logo

PAGE 25/58
119078.01 TELEPRESENCE T3 SYSTEM ASSEMBLY 12.08
TANDBE RG
Telepresence T3
4. Put the Center- and the Right monitor assemblies in place.
5. In order to level the systems, use 4 pcs of the (e) screw in the holes marked
in the picture below. Note that the picture illustrates the bottom module as
seen from above, with the door open.
6. Unpack the 2 angle plates and the 8 nut plates from the box marked ’T3
Table Floor Structure and brackets’. fasten with screws through the holes on
top side on the monitors and the bottom modules. The short screw at the
monitor top and the long screw at the bottom module top. Use the nut plates
inside the angle plate. Note that the top cover and the door must be opened
in order to do so.
M OUN TI NG T HE MO NI TO R
A SSE MB LI ES
4 × M4 × 40
4 × M4 × 12