-98-
tunnel.
z Server: In this mode, the Router responds the request
from the remote client for establishing a tunnel.
Account Name:
Enter the account name of L2TP/PPTP tunnel.
It should be
configured identically on server and client.
Password:
Enter the password of L2TP/PPTP tunnel. It should be
configured identically on server and client.
Tunnel:
Select the network mode for the tunnel. Options include:
z LAN-to-LAN: Select this option when the L2TP/PPTP
client is a LAN. The tunneling request is always initiated
by a router.
z Client-to-LAN: Select this option when the L2TP/PPTP
client is a single PC.
Max Connections:
Specify the maximum connections that the tunnel can
support. This item is available for Client-to-LAN tunnel type
on Server mode.
WAN:
Specify the WAN port to transmit the packets. This item is
available for Client mode.
L2TP/PPTP Server:
Enter the IP address of L2TP/PPTP server. (It’s always the
WAN IP address of the remote peer of L2TP/PPTP tunnel.)
This item is available for Client mode.
Encryption:
Specify whether to enable the encryption for the tunnel. If
enabled, the L2TP tunnel will be encrypted by IPsec, and
the PPTP tunnel will be encrypted by MPPE.
Pre-shard Key:
Enter the Pre-shared Key for IKE authentication. This item is
available for L2TP tunnel.
Client:
Enter the IP address of the client which is allowed to
connect to this L2TP/PPTP server. The default IP "0.0.0.0"
means any IP address is acceptable.
