TL-WR702N 150Mbps Wireless N Nano Router
- 85 -
5.9.1 Firewall
Using the Firewall page, you can turn the general firewall switch on or off. The default setting for
the switch is off. If the general firewall switch is off, even if IP Address Filtering, DNS Filtering and
MAC Filtering are enabled, their settings are ineffective.
Figure 5-34 Firewall Settings
¾ Enable Firewall - the general firewall switch is on or off.
¾ Enable IP Address Filtering - set IP Address Filtering is enabled or disabled. There are two
default filtering rules of IP Address Filtering, either Allow or Deny passing through the router.
¾ Enable Domain Filtering - set Domain Filtering is enabled or disabled.
¾ Enable MAC Filtering - set MAC Address Filtering is enabled or disabled. You can select the
default filtering rules of MAC Address Filtering, either Allow or Deny accessing the router.
5.9.2 IP Address Filtering
The IP address Filtering feature allows you to control Internet Access by specific users on your
LAN based on their IP addresses. The IP address filtering is set on this page:
