A SERVICE OF

logo

Channel 1* - CH1
Steering Servo - CH1
Speed Control - CH2
Channel 3* - CH3
From Voltage/Temp Senor Port - CH4
Battery* - BATT/CH5
RPM Sensor Port - RPM
Voltage/Temp Senor Port - V/T
* Not used
SLASH 4X4 ULTIMATE
11
Your model is equipped with the newest TQi 2.4 GHz transmitter
with Traxxas Link
Model Memory. The transmitter has two
channels for controlling your throttle and steering. The
receiver inside the model has 5 output channels. Your model is
equipped with one servo and an electronic speed control.
TRANSMITTER AND RECEIVER
Steering
Trim
Multi-Function
Knob
Throttle
Trigger
Throttle Neutral
Adjust
Steering Wheel
Power Switch Battery Compartment
Set Button
Menu Button
Red/Green Status LED
see page 33 for more info
Link
Button
LED
Sensor Expansion
Port
ESC/Motor Wiring Diagram
MODEL WIRING DIAGRAM
Antenna
Receiver
Velineon
Brushless Motor
(see side bar for proper
motor wiring)
Channel 2
Electronic
Speed Control
Channel 1
Steering Servo
Traxxas High-Current
Connector (Male)
to Battery
Motor
Cap
to Motor
LED
EZ-Set Button
(On/Off Button)
Heat Sink
VXL-3S ELECTRONIC SPEED CONTROL
Traxxas High-Current
Connector (Male)
to Battery
Auxiliary Port
(for optional use)
Receiver cable
(RX wire)
Cooling Fan
Connector
(for optional use)
TRAXXAS TQ
i
RADIO & VELINEON POWER SYSTEM
RPM
Sensor
Telemetry
Voltage Wire