SUMMIT
•
13
Always turn your TQ 2.4GHz transmitter on first and off last. This
procedure will help to prevent your model from receiving stray
signals from another transmitter, or other source, and running out
of control. Your model has electronic fail-safes to prevent this type
of malfunction, but the first, best defense against a runaway model
is to always turn the transmitter on first, and off last.
In order for the transmitter and receiver to bind to one another,
the receiver in the model must be turned on within 20 seconds
of turning on the transmitter. The transmitter LED will flash fast
red indicating a failure to link. If you miss it, simply turn off the
transmitter and start over.
Always turn on the transmitter before plugging in the battery.
Always use new or freshly charged batteries for the radio
system. Weak batteries will limit the radio signal between the
receiver and the transmitter. Loss of the radio signal can cause
you to lose control of your model.
TQ 2.4GHz RADIO SYSTEM BASIC ADJUSTMENTS
Throttle Neutral Adjustment
The throttle neutral adjustment is located
on the transmitter face and controls the
forward/reverse travel of the throttle trigger.
Change the adjustment by pressing the
button and sliding it to the desired position.
There are two settings available:
50/50: Allows equal travel for both acceleration and reverse.
70/30: Allows more throttle travel (70%) and less reverse travel (30%).
Note:
We strongly recommend to leave this control in its factory
location until you become familiar with all the adjustments and
capabilities of your model.
To change the throttle neutral adjust
position, turn the transmitter off before adjusting the neutral
position. You will need to reprogram your electronic speed control
to recognize the 70/30 setting. Turn to EVX-2 Setup Programming on
page 16 for instructions.
Steering Trim
The electronic steering trim located on the face of the
transmitter adjusts the neutral (center) point of the
steering channel.
Always turn your
transmitter on first.
Turn on the model.
1
2
Plug in the battery.
3
Remember, always turn the
TQ transmitter on first and
off last to avoid damage to
your model.
TRAXXAS TQ 2.4GHz RADIO SYSTEM
The following Traxxas High
Current Connector packages
are available from your
hobby dealer. When using
adapters, be careful not to
exceed the current rating of
the Molex connector.
Part #3060
Single Male/Female
Part #3080
2-Pack Female
Part #3070
2-Pack Male
Part #3061
Male Charge Adapter
Part #3062
Female Charge Adapter
5
T
U
R
N
L
E
F
T
T
U
R
N
R
I
G
H
T
Brake/Reverse
Lock Both Diffs
Lock Front Diff
Unlock Diffs
Neutral
Accelerate
Low Gear High Gear
TQ 2.4GHz RADIO SYSTEM CONTROLS
TQ RADIO SYSTEM RULES
