7
Installing the Phone
Installing the Battery
Use only the Uniden BT-1008 rechargeable battery pack supplied with your cordless telephone.
Activating the waterproof handset
The waterproof handset’s battery is already installed in the battery
compartment, but you have to activate it before you charge it for the rst
time.
Push the activation pin located on the bottom of the handset (see the
label with instructions).
Once you activate the handset, remove the label.
1.
2.
Press in on the handset
battery case cover.
Use the finger indention
for a better grip and slide
the cover downward to
remove.
Replace the battery
case cover back on the
handset and slide it
upwards until it clicks
into place.
Plug the battery cable into the
battery jack. Be sure to match the
red and black wires to the label
near the jack. The cable should
snap into place.
Gently pull on the battery cable. If the
connector comes loose, try connecting
again until the battery snaps into place.
Press in on the handset
battery case cover.
Use the finger indention
for a better grip and slide
the cover downward to
remove.
Replace the battery
case cover back on the
handset and slide it
upwards until it clicks
into place.
Plug the battery cable into the
battery jack. Be sure to match the
red and black wires to the label
near the jack. The cable should
snap into place.
Gently pull on the battery cable. If the
connector comes loose, try connecting
again until the battery snaps into place.
