3Com 520 Universal Remote User Manual


 
1-24
C
H
A
P
T
E
R
1:
G
E
T
T
I
N
G
S
T
A
R
T
E
D
Connecting to an IP Host on the Same IP
Network
To connect to an IP host on the same network using
FastConnect, enter
IPB
at the command prompt on
the Quick Configuration screen to display the screen
illustrated in
Figure 1-12
.
Figure 1-12
Connecting To An IP Host On The Same Network
Complete the fields on this screen as follows:
Remote ISDN Number
Type the ISDN number of the
remote unit that connects to the IP network.
Call Type
Set the Call Type for each ISDN number.
Use
64k Unrestricted
for Euro ISDN lines. Use
56k V.110
or
56k_restricted
in the USA depending on the
requirements of your ISDN service provider.
Remote IP Address
Type the IP address of the
remote IP host to which you want to connect.
Press [CTRL]+[E] to submit this information.
An entry is made in the autocall table so that if any
data destined to the remote host, a call is made
automatically and a connection made to the remote
IP network.
Enter
SAVE
at the command prompt to permanently
store this configuration in the unit’s memory.
Although calls to the remote site are only generated
when data is addressed to a specific IP host or hosts
(in our example, 191.000.000.100), any data that
cannot be identified as local is also passed over the
link while it is open. This can prevent the link from
closing after the intended data has been transferred.
Rc.bk : RC01.FRM Page 24 Thursday, July 10, 1997 9:53 AM