Filter
Top Products
8
Receiver Operations
Initial Settings
From the manufacturing facility, the receiver is configured as follows:
Line Locate Frequencies Selection Default
8 kHz Always Enabled Enabled
82 kHz
Always Enabled Enabled
Power Always Enabled Enabled
Radio Enable/Disable Disabled
CATV Enable/Disable Disabled
CPS Enable/Disable Disabled
Sonde Locate Frequencies
512 Hz Enable/Disable Enabled
640 Hz Enable/Disable Disabled
33 kHz Enable/Disable Enabled
Units inch or cm Inch
Power Frequency 50 Hz or 60 Hz 60 Hz
Contrast Up or Down Middle
Depth Measurement Live or One-Shot One-Shot
The setup function will allow you to enable or disable additional locating and
sonde frequencies.
Receiver Setup
Any of the available frequencies of the 3M
™
Dynatel
™
Advanced Pipe/Cable
Locator 2220M can be activated or deactivated. When a frequency is activated,
a check mark will appear beside the frequency in the middle of the setup screen.
All frequencies that are activated in the setup menu, will be available in the
locate screens.
When the Setup key is pressed, the receiver will cycle through the following
screens.
Select the left/right arrow keys (← →) to cycle through the setup screens.
Contrast Adjust
Press the up or down arrows ( or ) to
adjust the screen contrast.