Filter
Top Products
E-11
English
Using the remote control
Please keep in mind the following when using the
remote control:
< Ensure there are no obstacles between the
remote control and the remote sensor on the
front panel. e remote has a range of about 7
metres. (If the remote sensor is obscured, the
IR in remote control input jack on the rear
panel is available. Please consult your dealer
for further information.)
< Remote operation may become unreliable if
strong sunlight or uorescent light is shining
on the remote sensor of the unit.
< Replace the batteries when you notice a
reduction in the operating range of the
remote control.
Notes on batteries:
<
Incorrect use of batteries can result in hazards
such as leakage and bursting.
<
Do not mix old and new batteries together.
<
Do not use non-identical batteries together –
although they may look similar, dierent batteries
may have dierent voltages.
<
Ensure the plus (+) and minus (-) ends of each
battery match the indications in the battery
compartment.
<
Remove batteries from equipment that is not
going to be used for a month or more.
<
When disposing of used batteries, please comply
with governmental or local regulations that apply
in your country or area.
e BDP100 is supplied with the CR104 universal
remote control.
remote
control
Inserting batteries into the
remote control
2. Insert four ‘AAA’ batteries into the battery
compartment – two facing the top of the unit,
and two facing the end, as in the diagram.
3. Lower the end cap onto the plastic locating
plate in the handset. is acts as a hinge, and
you can now push the end cap rmly into its
locked position with a click.
1. Open the battery compartment by pressing
the button on the back of the handset.