Filter
Top Products
9
2
Technical Support:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
Email: http://www.addonics.com/support/query/
Quick Guide
Installing the 1:3 optical duplicator
Step 1
Insert the 1:3 Blu-Ray / DVD Duplicator into standard 5.25” drive bay.
Step 2
Connect the power cable from you system to the 4-pin floppy power connector.
Step 3
Connect the source drive to the source SATA port via SATA cable and the target
drives to the destination SATA port via SATA cable.
Step 4
Screw the duplicator into the drive bay with 4 screws (2 on each side).
Duplicating drive(s)
Make sure the source and target drives are connected to the proper ports.
When the duplicator is on, it will go through the steps below.
Step 1
Duplicator LED will light up and the device will beep.
Step 2
LCD will display initial steps:
1. Duplicator Ver: - Displays duplicator version
2. Initializing SDRAM
3. Detect Source/Target - Will detect the type of source/targets
4. Copy - Defaults to the first function which is to copy
Step 3
Once the duplicator gets to the copy menu, press ENT to begin copying. The
duplicator will auto-detect the drive and display its information on the LCD. Make
sure that the power LEDs of the flash reader are blinking, the blinking indicates
drive activity.
You can find the complete user manual of the 1:3 Blu-Ray / DVD Duplicator panel
on the driver disk under user guides. You can also download it from our website at
www.addonics.com/support/user_guides/
12.19 Quick Compare
Quick Compare is related to function#5 Compare. Once compare error byte reach to the setting
figures, compare process will stop.
12.20 Link Mode Select (Select Models)
Now press ESC and ▼ to enter the following screen. Press ENT to enter the “Link Mode Select”
screen. Use ▲ ▼ to choose between the Stand Alone, Middle Tower or Last Tower modes as
appropriate.
Attention: Once a tower has been set as Middle Tower or Last Tower and the J14 jumper is also set
to Target mode, the LCD will show that it is in Target mode.
12.21 Re-Scan (Select Models)
Now press ESC and ▼ to enter the following screen. Press ENT to enter the “Re-Scan” screen. By
default this is set to No. Use ▲ ▼ to choose Yes then press ENT to scan the chosen connected
tower.
12.22 Tray-In/Out
Lets you control the drive tray ejecting. The default is All Once and there have Divide 2 Times for
selection. The default is 5 second, more option is up to 99 seconds.
12.23 BootTime Delay
To set the device scanning time during the system booting.
12.24 Start Tray Eject
To set if do eject all tray after system boot up. The default is On. Press ▼ to select Off.
12.25 Disc Redetect
The function is designed specially for bad quality disc, the system will detect the disc one more
time if disc recognition error occurred. The default is Off. Press ▼ to select On.
12.26 Show Burn Speed
Now press ESC and ▼ to enter the following figure. This function lets LCD shows the burning
speed of CD/DVD/BD writers. The default is On. Press ▼ to select Off.