Filter
Top Products
Chapter 1 1-25
Installing Your Analyzer
STEP 5. Verify the Analyzer Operation
To Test the Reflection Mode
1. Connect the equipment as shown and press
.
2. Look at the measurement trace displayed
on the analyzer. It should be similar to the
trace below.
3. ES models only: Check the reverse
reflection mode for channel 1 by pressing
. The
measurement trace should be similar to the
trace shown below.
4. If you are ready to start making
measurements, continue with the next
chapter, “Quick Start: Learning How to
Make Measurements.”
Preset
Meas
Refl: REV S22 (B/R)