Filter
Top Products
ENGLISH
Searching with the index function
— Index Search
The unit automatically marks an index signal on the tape
each time recording starts. You can use these signals to
find the beginning of any recording.
Before starting
Set the TV VCR/CATV selector to TV VCR.
Press INDEX during stop or playback.
Press the number buttons (1 - 9) to select the index
number (up to 9).
Press g F FWD/] (for succeeding programs) or
f REW/[ (for preceding programs).
The unit starts searching.
Playback starts automatically from the beginning of the
specified recording.
To search the next index signal
Press INDEX during stop or playback, then press g
F FWD/] or f REW/[. When the next index signal is
found, playback starts automatically.
Notes
• Index signals should be at least 2 minutes apart. Otherwise,
the unit cannot detect them properly.
• Index signals may not be detected on damaged or worn out
tapes.
• Index signal at the beginning of a recorded tape may not be
detected.
• Index signal may not be detected if it is extremely close to
the point where the search began.
• When the tape reaches at the beginning, the unit plays back
automatically.
• During Index Search, when the tape reaches the end, Index
Search will be stopped and the tape is automatically
rewineded.
1
2
3
22
Searching the end of the recorded
program — End Search
You can fast-forward/rewind the tape at the end of the
recorded program automatically.
Before starting
Set the TV VCR/CATV selector to TV VCR.
Press REC. END SEARCH during stop.
The unit starts searching.
Searching stops automatically after fast-forwarding or
rewinding as below;
Fast-forward
Rewind
To stop End Search
Press s STOP on the remote control or s/z STOP/
EJECT on the unit.
Note
When the tape does not have blank space, searching stops at
the end of the tape.
recorded
recorded
Press REC.END SEARCH
Fast-forward
Stop
blank
blank
recorded blank
recorded
recorded
Press REC.END SEARCH
Rewind (after
fast-forwarding
for four seconds)
Stop
blank
blank
recorded blank
Press REC.END SEARCH
Fast-forward
Stop
later recordedlater recorded
blankblank
Previous recorded