Filter
Top Products
ENGLISH
Various search functions
1
2
Press CALL to display the tape counter.
Press RESET at the point you want to locate later.
The tape counter resets to “00:00:00.”
After playback or recording, press s STOP on the
remote control or s/z STOP/EJECT on the unit,
then press ZERO-RETURN.
The tape automatically stops when the tape counter
returns to about “00:00:00.”
Notes
• When you insert a cassette, the tape counter is reset to
“00:00:00.”
• The tape counter does not work while playing unrecorded
portions of tape.
CALL
sSTOP
RESET
ZERO-
RETURN
3
Rewinding or fast-forwarding to a
specific point – Zero Return
INDEX
TV VCR/CATV
gF FWD/]
fREW/[
Number
buttons (1-9)
Searching with the index function
— Index Search
The unit automatically marks an index signal on the tape
each time recording starts. You can use these signals to
find the beginning of any recording.
Before starting
Set the TV VCR/CATV selector to TV VCR.
Press INDEX during stop or playback.
Press the number buttons (1 - 9) to select the index
number (up to 9).
Press g F FWD/] (for succeeding programs) or
f REW/[ (for preceding programs).
The unit starts searching.
Playback starts automatically from the beginning of the
specified recording.
To search the next index signal
Press INDEX during stop or playback, then press g
F FWD/] or f REW/[. When the next index signal is
found, playback starts automatically.
Notes
• Index signals should be at least 2 minutes apart. Otherwise,
the unit cannot detect them properly.
• Index signals may not be detected on damaged or worn out
tapes.
• Index signal at the beginning of a recorded tape may not be
detected.
• Index signal may not be detected if it is extremely close to
the point where the search began.
• When the tape reaches at the beginning, the unit plays back
automatically.
• During Index Search, when the tape reaches the end, Index
Search will be stopped and the tape is automatically
rewinded.
1
2
3
20
CONTINUE